new plates
#1
i just got new plates for my AC 500 2005.
was wondering where exeryone else puts theres,
there is the 2 bars in the back i could strap it on.
or drill holes in the rear fender........i don't think so !!!!
was wondering where exeryone else puts theres,
there is the 2 bars in the back i could strap it on.
or drill holes in the rear fender........i don't think so !!!!
#2
Scooter,
i'm kinda new here so I'm going to assume you are talking about State Registration Plates. If not disregard from here on.
In PA the instructions say to install it as high as you can as close to the center as possible. On my 300 that means the plate would cover the brake light. I got 2 rubber lined 3/4" clamps at lowes and hung it on the right hand side from the rack.
The owner previous to me screwed it into the rubber cover on top of the rack covering the reflective Arctic Cat Logo. [img]i/expressions/face-icon-small-disgusted.gif[/img] Not me.
Harry in PA
i'm kinda new here so I'm going to assume you are talking about State Registration Plates. If not disregard from here on.
In PA the instructions say to install it as high as you can as close to the center as possible. On my 300 that means the plate would cover the brake light. I got 2 rubber lined 3/4" clamps at lowes and hung it on the right hand side from the rack.
The owner previous to me screwed it into the rubber cover on top of the rack covering the reflective Arctic Cat Logo. [img]i/expressions/face-icon-small-disgusted.gif[/img] Not me.
Harry in PA
Thread
Thread Starter
Forum
Replies
Last Post
OutRacing
Technical and How-To Articles
5
Sep 3, 2015 07:49 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)



