I put the Barnett Dirt digger clutches in 3 or 4 of my DS650's. they work good. But I don't abuse them.

 

OK, took the plunge. Installed a Barnett extra-plate clutch and a set of RWR 60% springs. The clutch has a stiffer pull but not too bad. Just like everyone has reported on previous installs neutral can be a bitch, SO I removed a little material from the clutch lever face were the cable slot is, that gave me some more throw out of the lever, ie the lever is a bit further from the grips, works perfect now!

 

I also run the barnett dirt digger clutch but i run three RW 60% and three of the barrnett springs and it is in a 770cc .

 

i run the same setup as hsr-tm, in my stock motor on a 20hp shot.