remote start/kill issues
#1
remote start/kill issues
I am attempting to install a standard remote alarm/start/kill on a 110cc go kart. Should be a simple install as there are a couple of nice diagrams out there. However, this kart has a 4 wire CDI w/o the black/white kill wire and a bit different than the available wiring diagrams.
I am created a wiring diagram and hoping someone can let me know how to properly hook up the remote. I am only interested in the start/kill features of the remote, not the alarm/lights/etc.
So for any electrical guru's out there it should be pretty easy...i'm just not wired that way (no pun intended!).
Normally the black/white kill wire from CDI is cut and spliced to the pink & grey wires on the remote. The blue wire from the remote then goes to the starter solenoid and the orange wire goes to the ignition switch. The remote red wire hooks to 12v supply and obviously black to ground.
I am also including a standard remote diagram.
Thanks,
Papa Buggy
I am created a wiring diagram and hoping someone can let me know how to properly hook up the remote. I am only interested in the start/kill features of the remote, not the alarm/lights/etc.
So for any electrical guru's out there it should be pretty easy...i'm just not wired that way (no pun intended!).
Normally the black/white kill wire from CDI is cut and spliced to the pink & grey wires on the remote. The blue wire from the remote then goes to the starter solenoid and the orange wire goes to the ignition switch. The remote red wire hooks to 12v supply and obviously black to ground.
I am also including a standard remote diagram.
Thanks,
Papa Buggy
#2
#3
Thread
Thread Starter
Forum
Replies
Last Post
jmelton
Ask the Editor
0
01-07-2016 06:58 PM
Currently Active Users Viewing This Thread: 2 (0 members and 2 guests)