baja 90 stator help
#1
baja 90 stator help
hi everyone I picked up a older Baja 90 cc with stator problems here is a pic of stator its a 7 winding the only replacement I can find for it is from here and they are out of stock https://www.chinapartsdepot.com/shop...exd.asp?id=749 I see lots 0f 6 winding stators are interchangeable or is there someway to put a aftermarket pickup on the quad thanks
#2
#3
By "pickup" are you referring to the coil that goes on the outside of the flywheel? I suspect this trigger coil will be the same on most Honda clone motors, so would take one off the cheapest 6 pole stator I could find, and solder it to your stator blue/white wire. Check it's mountings are the same, and that it doesn't hit the pip on the flywheel.
#4
no sorry I should have said source coil there is a coil on the stator that is a bigger coil then the rest with epoxy on it.it is wrapped with smaller gauged wire than the rest on the stator . I get 0 reading with a omhs meter when I test it and I can see where the stator bolts must have come loose and it rubbed against flywheel and broke some wires on it the rest of the stator is fine..i have read online but cant see what this coil does and can it be bypassed or do I have to find a stator that will fit thanks.
#5
#6
#7
7 pole stator
Hello, did you ever get this figured out? I have the same exact problem. Did you try the 6 pole?
dave
7
dave
hi everyone I picked up a older Baja 90 cc with stator problems here is a pic of stator its a 7 winding the only replacement I can find for it is from here and they are out of stock https://www.chinapartsdepot.com/shop...exd.asp?id=749 I see lots 0f 6 winding stators are interchangeable or is there someway to put a aftermarket pickup on the quad thanks
Thread
Thread Starter
Forum
Replies
Last Post
Holyman
Yamaha
2
01-05-2001 06:26 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)