Hello everyone, had a project dropped in my lap. Need some help please. As title states, I have no power to the ignition switch or the dash in general. Brand new battery, new ignition switch and no power to the front. Solenoid clicks when i put power to it and bike will turn over when i jump solenoid but I have no power. Any suggestions before I have to disassemble this thing and chase wires? Thank you in advance and have a blessed day

 

Power goes from battery to main fuse then to ignition switch and voltage regulator. No power to ignition switch means main fuse gone, or that wire from battery to fuse, to ignition switch is broken.

 

Ok so this one goes from battery to starter solenoid then wires and fuse that goes to ignition switch. Have power to solenoid but not the the wires going to ignition and fuse is good

 

Right, difficult to see colours on that pic, but the thicker wire in that multipin red plug will be the one going to the ignition, if there is no power on it there, the solenoid's fuse holder is broken. If there is power on it at the solenoid plug but not at the ign switch, the wire has a break in it.

 

Gotta be the fuse holder then. I can put power to the ignition wire at the plug and get life at key. Nothing at the blade. New solenoid ordered. Let you know when it comes in. Thank you for the assistance