400EX Handlebar Torque Spec
#2
I did noy know that we used a torque on the bars. Just lock tight the front bolts as tight as you can get them. Then tighten the back ones up. I am sure there is a spec but, maybe only one or two people use it. They are 10mm bolts and most 10's get about 30 ft/lps.
many 250r's
87 250x
99 400ex
many 250r's
87 250x
99 400ex
#3
#4
WHOA! LET GO OF THAT BREAKER BAR & SOCKET! hopefully you haven't done anything drastic yet.
Renthal recommends 17, that's seventeen, ft lbs of torque on their bars. Set torque wrench at 1/2 the torque and after tightening to that reset to 17 and re-torque. Torqueing over specs can weaken and damage the bars, being alloy.
Renthal recommends 17, that's seventeen, ft lbs of torque on their bars. Set torque wrench at 1/2 the torque and after tightening to that reset to 17 and re-torque. Torqueing over specs can weaken and damage the bars, being alloy.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)