Sitting Quad on Rear End
#1
Sitting Quad on Rear End
In some of the posts I've read about the Warn 424 and the installation process, some people have tilted their quads up and set them up on their @$$ end to install the unlocker. Will this do anything to the quad if it's left like this for a few hours? That's how long it will take to do the installation.
#3
Sitting Quad on Rear End
Drain the carb float bowl first, and of course turn the gas valve off. Gas can go back through the carb, and wash the oil out of your air filter, leaving you with no protection. On a Friday afternoon, I can stand on an I-10 freeway overpass and see 10 rigs headed for Glamis go by every few minutes, with quads standing up in the trailers. No big deal!
#5
#6
Sitting Quad on Rear End
Originally posted by: RedGoblin
What if I didn't drain the float bowl and just cleaned my air filter afterwards?
What if I didn't drain the float bowl and just cleaned my air filter afterwards?
I always tipped my Recon on end to wash the bottom. I would just turn the gas off before I tipped it up.
My Foreman is a little harder to tip up. It's a little bit heavier. The rear tires would skid on the garage floor. It was like moving a 600 lb wheel barrow. It would even skid when I'd try to block the wheels. It'd just push the block in front of the tires. I don't wash the bottom of the Foreman by tipping it up.
[img]i/expressions/face-icon-small-smile.gif[/img]
#7
Trending Topics
#9
Sitting Quad on Rear End
Originally posted by: Red400EXRod
Leave your gas turned off and start the engine. When the engine dies, your float bowl, and whole carb is empty of fuel. Now stand the quad up.
Originally posted by: RedGoblin
What if I didn't drain the float bowl and just cleaned my air filter afterwards?
What if I didn't drain the float bowl and just cleaned my air filter afterwards?
#10
Sitting Quad on Rear End
Originally posted by: Red400EXRod
Leave your gas turned off and start the engine. When the engine dies, your float bowl, and whole carb is empty of fuel. Now stand the quad up.
Originally posted by: RedGoblin
What if I didn't drain the float bowl and just cleaned my air filter afterwards?
What if I didn't drain the float bowl and just cleaned my air filter afterwards?
Thread
Thread Starter
Forum
Replies
Last Post
armpump450r
Technical and How-To Articles
7
04-01-2017 06:11 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)