hey slough... i have been having problems with my bike... and I wasnt sure if it was possibly the centrifugal clutch... how did you know that your was goin bad? what problems were you having? and did replacing it fix the problem?

 

<div class="FTQUOTE"><begin quote>Originally posted by: slough

hey gregg i had my centrifugal clutch rplaced by my dealer should i performe the initial setup or does the dealship do that</end quote></div>

Yes, reset the system as I outlined above to make sure it operates correctly

----- Gimp -----

 

<div class="FTQUOTE"><begin quote>Originally posted by: mxman76

thanks again gimp. i just have one more question, if my centrifical clutch is bad should i get it fixed first or go ahead and try this setup? and also is it ok to use my quad to push snow in electric mode?</end quote></div>

Sorry that I missed reading this post.
If you use it, make sure that the engine does not get too hot from the clutch slipping. If your centrifical clutch drum is warped, the clutch shoes/weights may not get hot and it can be ok

----- Gimp -----

 

you probably have water or a short in the angle sensor i have one in the shop right now for the same problem if it is still under warranty it should cover it


--------------------------------------


07' Honda Foreman ES

Maxxis Bighorns on ITP SS108s

warn xt30 with synthetic cable

 

Gimpster, Help. I went through this sequence and when I was returning to 1st gear it would only return to 4th gear.

 

Hello i am new to this forum and I have a 2006 Honda Rancher FGA that wont shift properly in automatic. I have followed through the steps posted by Gimpster regarding the downshift problem and cant get any codes to come up at the beginning and the display will not flash "--". It stays in 'N'. i tried turning it off and starting over several times with no luck. Could someone tell me why it wont show the "--" please. am i doing something wrong? thx