07 RINCON STALLING
#1
07 RINCON STALLING
I'm new to this site, hope I not repeating another post.
Anyway I have a 07 Honda Rincon fi. I ride a lot in West Virginia and had these problems more than once. If I go up a real step climb slowly it stalls out. It also has happened when I go through moderate mud hole. It just gets bogged down and will cut off. The machine all ways starts right back up. The dealer says they have been able to duplicate the problem but had no fix. I have stop doing a lot of climbs that my friends have no problem with, in fear of it stalling out and not being able to keep it from flipping. Any thoughts? By the way the gas is all ways fresh.
Anyway I have a 07 Honda Rincon fi. I ride a lot in West Virginia and had these problems more than once. If I go up a real step climb slowly it stalls out. It also has happened when I go through moderate mud hole. It just gets bogged down and will cut off. The machine all ways starts right back up. The dealer says they have been able to duplicate the problem but had no fix. I have stop doing a lot of climbs that my friends have no problem with, in fear of it stalling out and not being able to keep it from flipping. Any thoughts? By the way the gas is all ways fresh.
#2
07 RINCON STALLING
Welcome to the forum.
My guess would be bank angle sensor. There is a procedure to test it. I think you basically unbolt it, turn the key on with the sensor in the normal position and make sure the engine stop relay closes. Turn the sensor one way or the other, and the engine stop relay should open when the sensor is about 70 degrees.
My guess would be bank angle sensor. There is a procedure to test it. I think you basically unbolt it, turn the key on with the sensor in the normal position and make sure the engine stop relay closes. Turn the sensor one way or the other, and the engine stop relay should open when the sensor is about 70 degrees.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)