Honda rancher carburetor problem
May 14, 2018 | 04:49 PM
#1
Thread Starter
|
Trailblazer
Joined: Mar 2018
Posts: 28
Likes: 0
Honda rancher carburetor problem
I have a I have a 2003 Honda rancher 350 ES and I’m having some carburetor problems . It’s just been cleaned and will start if I spray some starter fluid in it or move the jet up and down to get it to r. It’s just been cleaned and it will start fine but it will only ring of unless I take the top of the carburetor off remove the spring and pull the jet up-and-down with my finger if anybody knows what my issue is please help me out thanks
May 15, 2018 | 01:56 AM
#2
Elite Pro Rider
Joined: Oct 2013
Posts: 7,465
Likes: 387
From: Lancaster England
"to get it to r. It’s just been cleaned and it will start fine but it will only ring of"
The above does not make sense.
If the CD piston sticks, either the needle is badly off centre, or there is dirt between piston and carb body. So check the needle is OK and clean carb body and piston where they slide against one another, smooth out with metal polish if they are rough. Check the diaphragm for holes, the piston isn't going to lift if air can get in and destroy the vacuum.
The above does not make sense.
If the CD piston sticks, either the needle is badly off centre, or there is dirt between piston and carb body. So check the needle is OK and clean carb body and piston where they slide against one another, smooth out with metal polish if they are rough. Check the diaphragm for holes, the piston isn't going to lift if air can get in and destroy the vacuum.
Thread
Thread Starter
Forum
Replies
Last Post
reconrider88
Honda
10
Apr 8, 2014 10:30 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
