I just received my Acceleration Mod and was about to connect it in. I checked
out the CDI to find the appropriate wires. I disconnected the 3 plugs off the CDI, found the
wires, and re-connected the plugs but forgot the first one to the left. I thought I would
check to see if this didn't screw anything up, (at this point Istill haven't connected the Accel
Mod . Not even cut a sigle wire yet) Itried to start the motor. It started but the belt light is
blinking and the RPM is slowed as if the belt is dammaged. Iopen the belt cover to check the
switch, it is in the on position. I tested the wire connection and it registered as closed
circuit. No matter what I try, this problem just wont go away.
It's Sunday, I want to go riding, the dealer is far from here and closed today,
so can anyone help me with this. Oh and by the way the belt is still in good shape.
PLEASE HELP!!!


________________________________

2003 , KVF 650 Prairie
26" Bear Claws
Back Springs
Accel Mod (in very near futur I hope)
fully equiped with everything but the kitchen sink.

 

Click on this.

This is a link to nyrocs belt light reset. It works great. That should fix you up.

 

THANK YOU .

Iwent to that site and found just what I was looking for.
Fixed it in no time.
I then installed my accel. mod., WHAT A DIFFERENCE!!
I didn't have the chance to really put it to the test, but
I'm sure this little box is all my Beast needed to break
loose.

________________________________



2003, 650 Priarie, red
accel. mod.
black springs
26" Bear Claws
full equiped