Hey all, I see many post here about the K&G factory clutch kit for the lakota and how it helps hook up a bit better so I just ordered the kit from the dealer. My question is , can this replacement be done without an impact wrench? If so can any one give me some pointers on installing them. Thank you...

 

well its pretty easy to install and only takes about an hour,we have replaced two lakota clutches,but i can't remember if we used an impact wrench or not.I'll check on it and get back with you.

 

That would be great, I appreciate it. I hope I don't need the impact wrench because unfortunately I dont have one. I placed the order today so the dealer says most likely it will be in on Thursday so hopefully I could get that in this weekend to do some riding to see the difference it makes. Thanks again for you help.

 

Clover,
I just checked out the service manual and it mentions having to use a special gear holder in order to keep the primary and secondary in place...Is that the case or can you get around that also...I also ordered the gasket , wasnt sure if it was possible to salvage the old one..