Hello i was just out today geting ready to replace my sprockets on my mojave so i first started off by removeing the plastic guard on the side of the motor after that i bend the washer back away from sprocket nut on the output shaft of the motor then i procceded to back the nut of the shaft with the drive chain still on but it didnt buge so then i put some WD-40 on it and tryed again with no luck so then i used my air impact on it and still didnt move at all so then i just put the impact on and let it go for like a minute and still nothing so if im missing anything or if some one has any good tecnqus for remove stuck nuts please feel free to let me know thanks yea i know i cant spell lol

 

dont know why it would be this way but the threads dont turn counter-clockwise do they?Maybe someone else on here could enlighten us on this.

 

so wait you mean you turn the nut to the right like right lossy leftey tighty

 

I kinda doubt thats the problem but you might try it.

 

well i tryed heating it up to day and still nothing did you ever have this problem

 

them is a tuf queston ya got ther sun wunder if yer kounter shafts got one a them ther snap rings on it mabe

 

use brake fluid or seafoam to penetrate

my air impact would shatter or at least strip any nut on an atv, you must be using a small compressor or set to low pressure