My friend has a 2000 prarie 400 4x4 with full time 4x4. It began pulling to one side and we noticed the right front ball joint was bad and it was replaced. Now it seems like the front end is loose. Just pulls left and right and all over the trail with any speed at all. We checked everything.....all is tight. However we noticed the machine is severly out of align. Measuring the front of the front tires gives a two inch difference than the rear of the front tires. The local dealer says there is no way to adjust the alignement. Can this not be done by adjusting the tie rod ends? If so what is the correct toe in/out? My polaris manual recomends 1/8 to 1/4 inch toe out. Any help would be appreciated.

 

the toe should be about the same as your polaris , 1/8 to 1/4 toe out.