Looking for info on the keihin 20mm carb
#1
Looking for info on the keihin 20mm carb
Hello all,
I just purchased the keihin carb for my sons Lt80. I have a trinity stage 3 ported cylinder, modified reid cage, boyseen reeds, and I run our compression around 165 - 170. My clutch has been modified, and I regeared with better chains and sprockets. Could anyone tell me where approx. the jetting should be in that carb? Does anyone else run that carb on the Lt80 motor? I installed a case vent filter onto the belt housing, and routed it up under the gas tank to keep it clean. Has anyone found any problems with doing this?
Thanks for the info,
DStroyer
I just purchased the keihin carb for my sons Lt80. I have a trinity stage 3 ported cylinder, modified reid cage, boyseen reeds, and I run our compression around 165 - 170. My clutch has been modified, and I regeared with better chains and sprockets. Could anyone tell me where approx. the jetting should be in that carb? Does anyone else run that carb on the Lt80 motor? I installed a case vent filter onto the belt housing, and routed it up under the gas tank to keep it clean. Has anyone found any problems with doing this?
Thanks for the info,
DStroyer
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)