Rear sprocket to Adly 300?
#1
Back sprocket to Adly 300?
Hello everyone out there!
I`m a 25 year old guy from Sweden that drives a Adly 300. I am very satisfied with the machine soo far. The only moifications I have done is that I have put on a bigger front sprocket (14T) (to make it rew less) because I drive mostly on highways on high speeds. Despite the bigger front sprocket I think it rews to much on high speeds so I am desperat for a smaller rear sprocket, but I can`t find it anywhere. So my question is if anyone know where to find a smaller rear sprocket to my Adly.
Best regards
Dany
I`m a 25 year old guy from Sweden that drives a Adly 300. I am very satisfied with the machine soo far. The only moifications I have done is that I have put on a bigger front sprocket (14T) (to make it rew less) because I drive mostly on highways on high speeds. Despite the bigger front sprocket I think it rews to much on high speeds so I am desperat for a smaller rear sprocket, but I can`t find it anywhere. So my question is if anyone know where to find a smaller rear sprocket to my Adly.
Best regards
Dany
#3
Rear sprocket to Adly 300?
Hey get away from adly it¨s junk machine is like from 1980 year frame like welded in kindergarden , burning C.D.I. , regulators , broken piston rings , instrument damaged from wather ............
Sprocket are posible to make in every ing. mehanical workshop or buy in Austria
Sprocket are posible to make in every ing. mehanical workshop or buy in Austria
#4
Rear sprocket to Adly 300?
Thanks for your in depth analysis by my machine [img]i/expressions/face-icon-small-smile.gif[/img]. I have driven about 2500 km with my Adly and no problems so far, so I am not concerned about the quality.
So maybe someone else got some bit more relevant answer to my question:
Where can I by rear sprockets to my Adly?
Dany
So maybe someone else got some bit more relevant answer to my question:
Where can I by rear sprockets to my Adly?
Dany
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)