49cc a t v wont start without using either
#1
#2
#5
If you need to adjust your valves on a GY6 moped I recommend 0.004 for the top one (intake valve) and 0.005 for the bottom one (exhaust valve). But make sure to make the adjustments when your piston is in its top death center. This can be done by inspecting your flywheel and aligning the T letter to the lining mark and if so also check the camshaft lining. It should have two small holes that should be perpendicular to the cylinder head and also a bit hole on the camshaft that is facing outwards from the cylinder head. This way your cylinder should be in its top death center. Then you can adjust your valves. That is what I know. Hope it helps.
Thread
Thread Starter
Forum
Replies
Last Post
VENOM_MOTORSPORTS1
Classifieds, Garage Sale & Swap Shop
0
10-13-2016 05:10 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)