Nerfs Installation/Suggestions
#1
#3
Installing the Graydon's wasn't hard at all. First you might have to remove the stock black mud guards, and then loosely install the center bar and u-clamps that attach to the frame in front of the motor. Then you clamp the rear part onto the stock foot pegs...I used two pair of vise-grips...and drill the holes to bolt up the rear section of the nerf bars. Then you simply make sure everything is aligned correctly and tighten up all the bolts. On my 400EX, I had to use a Dremel tool to trim the plastic mud guards so they'd fit again, as the rear section of the nerfs turned upwards into them.
#6
#7
I have graydons they took about 20 mins to install. Make sure what ever ones you buy you can replace the nets. The nets were the hard part. I used a pair of neddle nose pliers and pulled them through the bracket. Gradton alumium would be my choice. But i could not not buy AC racing nerfs. They discontinued they for the quadzilla..
Thread
Thread Starter
Forum
Replies
Last Post
ElementzzofStyle
Performance Mods and Project Quads
3
08-29-2015 10:45 AM
ATVC Correspondent
Classifieds, Garage Sale & Swap Shop
0
08-25-2015 11:16 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)