I just replaced my clutch lever, got rid of the bulky stock one with the ebrack and all that crap on it...however it seems like the cable is too long now, as soon as i release the clutch a HAIR literally it engages. it barely goes into gear while i have it squeezed tight...i have the thumb screw out as far as it can go without coming out,,is there anywhere else I can tighten the cable?

 

Try lookeing on the right side of the crankcase where the clutch is then you will see a little fork like thing that the cable is going to loosen it up tahe it off and move it to the rear of the machine until your clutch is tightened up how you like it.

 

I'm not sure I'm understanding what you're saying, I know where the cable is connencted near the crank case, then what do I do?

 

you take it off usually it is held on by a bolt, and move it to the rear of the machine then slip it back on.