4 wheel drive
#11
#12
#14
I checked the resistance on the resistor it was a little off but I took it off and cleaned the resistor chip. Plugged it in and now ever gear shows on the Speedo. Still no awd. It is not lighting up on the Speedo and I can free spin the shaft coming out of the front dif. I still have voltage on the wire going to the front dif.
#15
#16
Connections may have been a problem or the speedo itself,but it's been bypassed as far as the awd is concerned. If you have power to the dif grey wire and have made a better ground,problem could be in the diff coil itself or a mechanical problem with the roller cage.If coil is ok,it should show between 22.8-25.2 ohms between the gray and brown/white according to the manual.If it's within range, might be that another cracked plastic roller cage is the problem.
#19
#20
Change out the plastic roller cage and armature plate no matter what since you're already in there. The cage can have small cracks hardly visible that can cause engagement problems.I'd also check out the coil plate with 12 volts also to make sure it's pulling the armature plate. Again if you've jumped the speedo connector brown/white wire to another brown or a better ground,you've eliminated the speedo from interfering with awd engagement.