NO reverse In Scrammy 400 again,,This time I'll remove it! help!!!
#1
NO reverse In Scrammy 400 again,,This time I'll remove it! help!!!
After the two previous times,my Tranny spun reverse again.
Last time it happend it was because I had a problem with the motor spinning backwards ,which pushed the snap ring (that holds the reverse gear) down the shaft which made the gear unable to engage.
This time I don't know why it happend but it must of happend again.Last time I had the trans apart I CHAGED the snap ring and the gear,,so,I don't know how it happend but it did.
Well,because of this problem and the fact that I don't want to spend any money on a WHOLE new trans I'm planning to just Take out reverse.I'm only going to use it for drags and other races anyway so WHY NOT!!
The only problems I have is What do most ofyo do to remove this.Do you take all the two gears out or just the top,or just the bottom.I know these trannys well and have had them apart before,,if the bottom gear comes off how do you keep the drive gear from moving(i never took apart the lower two gears from the shaft)from what I can see it looks like it could shift over without the reverse gear.also it looks like the gear would be the only thing holding the bearing from moving.
JUST TELL ME HOW TO REMOVER ALL THE GEARS FOR REVERSE!!
Also HAVE ANY OF YOU NOTICED ANY PREFORMCE INCREASE FROM DOING THIS!!!
Thanks
matt
Last time it happend it was because I had a problem with the motor spinning backwards ,which pushed the snap ring (that holds the reverse gear) down the shaft which made the gear unable to engage.
This time I don't know why it happend but it must of happend again.Last time I had the trans apart I CHAGED the snap ring and the gear,,so,I don't know how it happend but it did.
Well,because of this problem and the fact that I don't want to spend any money on a WHOLE new trans I'm planning to just Take out reverse.I'm only going to use it for drags and other races anyway so WHY NOT!!
The only problems I have is What do most ofyo do to remove this.Do you take all the two gears out or just the top,or just the bottom.I know these trannys well and have had them apart before,,if the bottom gear comes off how do you keep the drive gear from moving(i never took apart the lower two gears from the shaft)from what I can see it looks like it could shift over without the reverse gear.also it looks like the gear would be the only thing holding the bearing from moving.
JUST TELL ME HOW TO REMOVER ALL THE GEARS FOR REVERSE!!
Also HAVE ANY OF YOU NOTICED ANY PREFORMCE INCREASE FROM DOING THIS!!!
Thanks
matt
#3
#5
Thread
Thread Starter
Forum
Replies
Last Post
TegraQuad
1) Engine problems..
13
11-26-2017 01:40 PM
02Chevrolet
1) Engine problems..
2
06-23-2015 12:12 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)