Front Hubs '01 SP 400
#1
Front Hubs '01 SP 400
I'm getting ready to change the fluid. I have never done this and was looking for a little instruction on how to do it, what I need and what type of fluid to use. I did a search and was able to get some idea on how to do it and how to fill it at 4 & 8. If anyone has any helpful hints I'll listen. Thanks.
#2
Front Hubs '01 SP 400
Instructions from service manual (99-00 Scrambler)
1. Put drain pan under hub.
2. Remove hub cap (3 screws and pry equally on edges)
3. Allow fluid to drain
4. Inspect cap o-rings for nicks cuts..., replace if necessary
5. Remove check/fill plug
6. Reinstall hub cap (fill plug must be removed before reinstalling cap)
7. Turn filll hole to 4:00 or 8:00 position
8. Add polaris demand drive hub fluid until fluid trickles out. ( DO NOT force fluid in under pressure)
================================
Polaris Demand Drive Hub Fluid:
PN 2871654 - 8 oz.
PN 2872277 - 2.5 gallons
================================
I assume it would be the same steps for yours.
1. Put drain pan under hub.
2. Remove hub cap (3 screws and pry equally on edges)
3. Allow fluid to drain
4. Inspect cap o-rings for nicks cuts..., replace if necessary
5. Remove check/fill plug
6. Reinstall hub cap (fill plug must be removed before reinstalling cap)
7. Turn filll hole to 4:00 or 8:00 position
8. Add polaris demand drive hub fluid until fluid trickles out. ( DO NOT force fluid in under pressure)
================================
Polaris Demand Drive Hub Fluid:
PN 2871654 - 8 oz.
PN 2872277 - 2.5 gallons
================================
I assume it would be the same steps for yours.
#3
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)