...on my 2000 scrammy 500 4x4? i can't figure it out ( well, haven't really tried), and i can't find it in the manual. i just don't want to mess it up. thanks,

bruce.

 

no one?

 

ok if you have the factory service manual it is on 7.13
Says remove the axle, remove the seal sleeve from strut housing using a drift punch and hammer (looks like you do this from the inboard side so since you have to disconnect the tierod to get the axle out anyway you can just turn the whole strut assembly sideways to get at the back.) tap the seal sleeve on each side so it comes out evenly. then it looks like the coil will just slide out and you'll have to dig out the silicon from the strut and then resilicon it when you put it back together.

 

ok. thanks eric.