scrambler 90 sucked in water
#1
scrambler 90 sucked in water
My daughter went through a fairly good size puddle and apparently the two screws on the bottom of the air filter werent tight and allowed water in. I pulled the plug and cleaned it and have the filter box cpompeletly off, but still wont start.
Any suggestions?
Any suggestions?
#5
scrambler 90 sucked in water
If you pull the plug out, put the wire on it, and put the edge of it against the block, and turn it over you should see a spark. You could have gotten the coil wet which would cause it to not work correctly. I would think by now it should have dried out though unless it is permanently messed up.
#6
scrambler 90 sucked in water
Tried a new coil off of a friends quad (same engine) but still no spark. Next in line is a black plastic box with lots of wires. Could that cause no voltage to coil? The ground wire that attaches to the coil is pretty fried, but I don't know if that was old or just happened.
#7
Trending Topics
#10
scrambler 90 sucked in water
Check to see if the plug is firing like they said. If it is firing then you dont need a cdi. They are sealed so I'd say it wouldnt be that but may be your ground wire still. More than likely it needs dried out so take out the spark plug and the airfilter off and let it sit for a day than try it. I have used CDIs if you need one.