clutch cover
#1
#2
its really basic if you look at it as far as the bolts that hold the foot well on and either screws or just push plastic butons that hold the plastic together. as far as the cover, just take off all the screws, just make sure that they are the same size and if there is a longer one that you put it back in the right hole. i think its either a 3/8" or 10mm socket and extentions and your good to go. oh yea dont forget to unhook the clamp that holds the cover vent on that goes up by the tank.
Thread
Thread Starter
Forum
Replies
Last Post
fordfaithful21
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
9
12-07-2015 05:52 PM
cdstang
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
2
08-31-2015 07:52 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)