I need to replace the kill switch controls on my 800. It quit working so I took it apart to check out if the contacts needed cleaned up and found the contacts are melted into the switch. I tried to fix it and put it all back together but it would only work when you pushed in on the switch. I ended up just ordering a complete housing and switches new but I will have to remove my grip to take the old one off and the new one on. Has anyone tried getting them off successfully without messing them up? I have the Hot Grips by Symtec. I havent looked yet but do they sell just the grips as replacements without having to buy the controller and everything else. Hopefully so I can save a few bucks. Thanks for the help fellars!

 

I was able to buy just the heat elements and I think it set me back $15 american dollars. And MAN DID THEY WORK BETTER!!! I was suprised at how much warmer they were and how much faster they warmed up

 

This might help you out.Replacement "No Adhesive" Left Grip for 210029 or 210050

 

Thanks! From what I've read you just have to cut them off. I got one ordered from the link provided from you Ram It. Thanks for all your help guys!

 

You can spray some wd-40 in them and they should slide off.