Trailblazer 250 starting problem
#11
05-11-2017, 06:51 PM
#12
05-11-2017, 07:00 PM
Polaris ATV Expert
Retired and loving it!
Retired and loving it!
110 psi is over the 100psi minimum the manual calls for,but I've see them run at that and a tad lower if everything else was ok.If you still have a revving problem,have sprayed wd 40 or contact cleaner around the intake manifold and base gasket with no change in the engine,then I'm still thinking crank seals. Especially the troublesome one behind the drive clutch. Cheap parts that can cause problems.Polaris Trail Blazer 250, 1990-2006, Engine Crank Seals | eBay
#13
05-12-2017, 11:04 PM
Join Date: May 2017
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
#14
05-31-2017, 06:15 PM
Join Date: May 2017
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
#15
06-01-2017, 09:36 AM
Polaris ATV Expert
Retired and loving it!
Retired and loving it!
#16
10-30-2020, 09:05 AM
I have recently got a 2000 Polaris trailblazer 250 2 stroke. It did not run when I got it then I cleaned the carb.It started on starting fluid then I could drive it around the yard and then after I shut it off it would not start by itself again.So I took the carb apart and cleaned it several times and that didn't work.Bought a rebuild kit for it and it still doesn't work.I cleaned the carb again,fresh fuel, new plugs. I would buy a new carb for it but can not find one for it anywhere. It also has been revving really high while just idling.So any help or advise would be helpful,this us my first two stroke.