Preditor 90 plug fouls
#1
Preditor 90 plug fouls
I purchased a Preditor 90 / 2003, we have used the quad about 3 times so far. When I first got it it would start right up and idle fine.
After the first tank of gas (which had the break-in mix as recommended) the darn think won't start up right away.
I hit the starter it pops a few times then stalls. I had it back to the dealer and the service tech changed the plug.
It ran fine untill the next time I tried to start it, just would not go. It seems every time I use it I have to pull the plug, clean it and then it fires right up. (The plug is wet when I pull it out)
Since its under warrenty I'm sending it back to the dealer I was just wondering if anyone had any advice.
I was told to choke it for no more then 30 seconds when it first starts because it wil load up.
I was also told to remove the throttle restrictor and run it out before putting it away to prevent the plug from fouling. (doesn't seem to make a difference).
Its my sons quad so it gets a bit frustrating when we gear up to go and I have to do plug maintenence to start the thing every time.
I think we have about 18 hours on the machine and 90 percent of the riding is in open fields.
Thanks in advance
After the first tank of gas (which had the break-in mix as recommended) the darn think won't start up right away.
I hit the starter it pops a few times then stalls. I had it back to the dealer and the service tech changed the plug.
It ran fine untill the next time I tried to start it, just would not go. It seems every time I use it I have to pull the plug, clean it and then it fires right up. (The plug is wet when I pull it out)
Since its under warrenty I'm sending it back to the dealer I was just wondering if anyone had any advice.
I was told to choke it for no more then 30 seconds when it first starts because it wil load up.
I was also told to remove the throttle restrictor and run it out before putting it away to prevent the plug from fouling. (doesn't seem to make a difference).
Its my sons quad so it gets a bit frustrating when we gear up to go and I have to do plug maintenence to start the thing every time.
I think we have about 18 hours on the machine and 90 percent of the riding is in open fields.
Thanks in advance
Thread
Thread Starter
Forum
Replies
Last Post
Hankey Pankey
Performance Mods and Project Quads
3
05-01-2018 01:33 PM
Hankey Pankey
Performance Mods and Project Quads
0
08-17-2015 05:01 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)