Lashing Valves help?
#1
Lashing Valves help?
I am getting ready to lash my valves on my Raptor tomorrow. I see there are different specs to adjust these to. Should I go for the higher or lower value? I thought about using the larger value the .15 and .20mm in case the valves were to keep tightening up but I am not sure if they will tighten anymore now that it has been broken in? What spec should i try for my valves? Will they tighten more now that its broken in or will they start to get more loose? This is the first time I have lashed my valves about 20-30 hours on my fourwheeler. I checked the intakes with a .152mm and all of them were too tight to fit that in between.
Thread
Thread Starter
Forum
Replies
Last Post
Scooter's Shop
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
23
10-22-2015 07:04 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)