I just purchased a tether switch for my new yfz450 and was wondering if anyone knew how to install one or could tell me where i could look for some help. Any help would be appreciated thanks.

 

is ia a pro design kill switch? If so you can go to their web site and they have instuctions. I just bought one for my friend's quad and will be installing it sometime this week on a yfz450. I'll keep you up to date when we finish if you haven't figured it out by the directions yet. I know that it had to be connected to the coil wire on my raptor but not sure right now for the 450

 

mines made by Tusk off road i think i found a way to hook it up but havent had a chance to try it yet. ill check out those directions. thanks

 

Should be a white wire in the harness by the left side headlight, tie into that and ground the other to frame. Use a headlight mount bolt or such.

 

thats what i thought thanks for the help

 

i wired up my tether switch and when i tried it to see if it worked right it worked backwards of what its supposed too. does anyone know what i did wrong.

 

did you use the right wire and not the ground?

 

i tried both of the wires and it worked the same either way.

 

according to my dealer there is a special teather designed for the yfz450... just like the one they use on the bikes i guess... its 80$
i wanted to just run my old teather so i dont hafta buy another one... but i dunno... ive never heard of others running a special teather so i am sure there is a way to get the pro design to work.