Raptor Clutch help needed.....please
#11
Raptor Clutch help needed.....please
I will be taking out the EBC I have in there now. I know it had the two different fiber plates and stronger springs. But has always not felt right. Looked at it again and still all looked correct. So all I can do now is put in a new clutch, just want to make sure it will work. I might just stick my stock clutch back in, it was working fine. I just changed because my case started leaking and figured I would change the clutch while I had it open. Should of went with the saying if it aint broke don't F with it.
#12
Raptor Clutch help needed.....please
How do you get to that last bolt. I wound up taking my whole motor out. Glad I did because the rod was worn a bit so I'm replacing it. In the future however how do you remove the clutch cover? I assume you need to angle it somehow to get to that last bolt... do you angle up or down?
#13
Raptor Clutch help needed.....please
ahhhh yes that annoyinh little bolt on the bottom left of the cluutch cover. It ALMOST seems like you have to take the motor out, but you just need to move the case around at weird angles and make sure that bolt is pushed in halfway so it doesnt catch on the frame. It was a real pain in the butt for me as well.........
#17
#18
#19
Raptor Clutch help needed.....please
whats wrong with you people, a 8mm open end wrench will take take of that one perticular bolt, it doesn take me more than 15 min to completly change my clutch. if you were going to take the motor out of the frame, WHILE YOU HAVE IT OUT, I STRONGLY SUGGEST HELI-COIL EVERY THREAD FOR SUPERIOR STRENGTH.
#20
Thread
Thread Starter
Forum
Replies
Last Post
cdstang
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
2
08-31-2015 07:52 AM
ATVC Correspondent
Classifieds, Garage Sale & Swap Shop
0
08-25-2015 11:16 PM
ATVC Correspondent
Classifieds, Garage Sale & Swap Shop
3
08-21-2015 01:23 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)