I have a k&n stock replacement on my 660 and i wanted to know what i should get.A k&n clamp on from pro design and try and sell my drop in so i can run it without a lid, or a k&n powerlid?

 

hello? I know there are plenty out there with these mods....come on guys...gettin lonely here....

 

I have the Powerlid and like it alot. Supposed to have a 8 HP gain. I didn't like how it ran with the jets included with the set, so I bought Dynojet's Stage 2 Kit and have had no problems.

 

I would get the lid, my 2 cents

 

You'll get much better performance with a Pro Design Pro-Flow K&N so ditch the lid all together. Not only will it be easier to rejet but you'll only have to clean one K&N filter, not two.

 

i dont see how anyone can argue that the pro design flange with the outerwears isnt the best setup,,,because it is,,,JMO

 

I have a drop in K&N with an EHS Lid. www.ehsracing.com I love the set up in my opinion. When it is time to clean that filter. That screen on that lid is so dirty.....you just thank yourself for putting that on there.

 

yea,but you cant beat the clamp on,,,nothing can get past that

and the outerwears also acts like a prefilter,and for me i have the Univents in the airbox lid on top of all of that,,,,its like having 4 layers of protection,,,the flange instead of the sloppy drop in,the filter,the outerwears,and the Univents,,,thats just too hard to beat

 

I got the drop in but prolly going to get the pro-design set up soon and the K&N power lid and it works really well. the power lid comes with a K&N pre-filter so it doesn't get really dirty

 

I used the EHS Lid with a Pro Design adapter and K&N filter, loved that setup until I went with L&A Designs filter setup, no airbox, filter basically clamps onto the carbs. That's the best setup.