I bought this banshee used a few months ago and the guy said that it was ported by CT. It also has CT pipes. It doesn't say anything on the sides of the cylinders. I called CT and they said that they usually engrave on the sides to show that it was ported. This one does not have any engraving on the sides. Last night I took the coolhead off to see what domes where in it and it does look ported to me but I am very far from being an expert. Here is the link to two pictures. http://comp.uark.edu/~abiossa/banshee.html What do you guys think? These are the best pictures I could get with the engine still in the frame. Thanks a bunch!

Adam Biossat

 

it looks like theres been some grinding done but it's real hard to see from those pictures, the best way is to pull off the intake and look into the cylinder, you should beable to tell then

 

Ya it looks like it, but it does not look like a very good job of porting according to those pictures. But who knows?

 

If you can take the reed cage out, you should be able to tell then, if its rough and bumpy then odds are it hasnt been, if its nice and smooth chances are it has... I think..

 

looks like a clean up port to me.