I just replaced my clutch lever, got rid of the bulky stock one with the ebrack and all that crap on it...however it seems like the cable is too long now, as soon as i release the clutch a HAIR literally it engages. it barely goes into gear while i have it squeezed tight...i have the thumb screw out as far as it can go without coming out,,is there anywhere else I can tighten the cable?

 

where the cable goes into the perch adjust that screw in and reset the lock nut

 

Yeah, at the bottom mounting point of the cable. You can also pull the arm off the clutch shaft and move it over a couple notches on the splines to take up some of the slack.

 

I adjusted the screw on the perch and its liiterally out on the last thread, i'll have to try to adjust it at the clutch shaft like recon99 said..

 

adjust it IN not out..

 

If I thread it in (to the left) the line loosens up and it's useless.