Need a little advice....
#1
I just bought a PRM bumper for my warrior. The reason I got it is because my stock one is bent up from the wreck I had in a race last summer. It bent the right side down an inch or two where the bar mounts up. What I need help with is what is the best way to go about bending it back up so I can get my new bumper mounted right? Ive tried whacking it with a hammer with no luck. I was hoping that someone might have a little trick to get this thing bent back. Thank you[img]i/expressions/face-icon-small-cool.gif[/img]
#2
Chain it down solid & put a jack under the low side & SLOWLY jack it up till it's level with the other side. Be cautioned though if it's bent bad enough it may crack a weld or tube & be careful what you use to tie it down , if it's not as strong as the part your straighting you may rip it off. Do it at your own risk.
Thread
Thread Starter
Forum
Replies
Last Post
Canyon Doug
Polaris
10
06-19-2011 06:39 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)