What is the best way to get a lil more low end on the blaster.....the money should be rolling in and before i get my 240 kit,is the vitos(or pro x) piston good for all around power,same with the v-force reed valve???I love the top end power the toomey gives but want a couple mods for a lil more low end before i start gettin buckwild on the blaster!!

 

I would also like a little more low end power for my blaster.

 

A long rod or stroker crank, higher compression, advanceing your ignition.....will all help with low end power. You can also change you gearing (smaller front, larger rear sprocket, or smaller rear tires).

 

If u get smaller rear tires it will feel like there is more low end but it will also make the gears a lot shorter so your top speed wouldnt be very high

 

Hey Peltrax how ya been? You can pick up very noticeable bottom end power with a degree key on your flywheel. I did that on two Blasters, and it's inexpensive (get it from Vitos) and didn't cost any top end. One of them did shear though, they are not as strong as stock being offset-ground. I would say just wait for the 240 kit though. Make sure you have it ported and the head mod done to give you 165psi or better. It'll scream!

 

this thread was started nealy two years ago.

 

2 years?

This thread was created on Tue September 03, 2002 8:29 PM

This thread isn't even a year old yet dude..last time I checked it was July 2004...but then again I did hit my head really hard during that crash..how long was I out?

 

Aw crap, I hadn't noticed that. I think Peltrax went in the service.

 

dude. you are the retard. this thread was started september 03, 2002.
it is july 13, 2004. simple math states that this thread is nearly two years old.

 

wow dude don't get all bent out of shape..Im jsut messin with you.

I don't really give a **** how old this thread is..