I've about had it with this jet kit garbage!
#11
#12
#14
#15
I've about had it with this jet kit garbage!
Not sure if the carbs are the same but on mine to get to the needle you take out the screw that holds the arm on the rod that pivots to bring it up and down. Then you pull theh rod out the side of the carburator (its attached to the throttle.) For the life of me I couldnt get a 400ex carb apart to get to the needle.
#16
I've about had it with this jet kit garbage!
yeah i would say run 260+- at sea level. toomey says bring the needle up one, and my pipe came with a 310. too mucha fo you! and then he said to take the airbox lid off and leave it off! {after i drilled all those holes!!!!}
if you re prob is low end, its prob needle position. watch yer plug. nice light brown.
[img]i/expressions/face-icon-small-cool.gif[/img]
if you re prob is low end, its prob needle position. watch yer plug. nice light brown.
[img]i/expressions/face-icon-small-cool.gif[/img]
Thread
Thread Starter
Forum
Replies
Last Post
700Wildcat
Hunting, Trapping, Game Management
9
05-09-2005 04:05 AM
fishbones
Land, Trail and Environmental Issues
2
03-04-2002 10:52 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)