The starter gear cover when I was putting everything back together after changing my one way. I have another on order, but how do I get that stinkin' bearing out of the old cover?? Drill a hole and push from the backside or what? Any advice is appreciated!!

TX

 

using heat from a propane torch warm the side case evenly around the bearing....this expands the case and allows the bearing to be "pulled" easier, you might still need a bearing puller(slide hammer style)




BRAAAAP

 

I would call Concho Valley Motorsports and see if they can help.[img]i/expressions/face-icon-small-happy.gif[/img] They can also get factory parts faster than PHIC. Ride on!!! XR