Problems with 03 Blaster........
#1
Lately when ever I gun it...it hesitates for like 3 or 4 seconds then takes off. This happens alot. Also there is this tube hangin off the carb and gas or oil or both is leakin out of it at a large rate. any ideas? TIA
#4
you could take it to the dealership sure, but you arent always gonna have that warranty, and im pretty sure that you arent gonna wanna pay their prices for basic stuff like that.
To take the carb off, you first turn off the gas, and run it until it dies, so that the carb is empty. You then unscrew the two bands on either side of it. Next unhook, on the left, the fuel line, and on the right, a very thin black tube, the oil injection tube. there are a couple orange lines coming out the bottom, dont worry about them, they stay on. Next, unscrew the little side clip that unscrew the top of the carb. Be careful not to loose any pieces out of it. The carb shoudl then be free.
Turn it over, and there should be four little screws. Unscrew these, and take that cover off. look to see if there is any sediment, or anything blocking the floats.
Hope this helps
Josh
To take the carb off, you first turn off the gas, and run it until it dies, so that the carb is empty. You then unscrew the two bands on either side of it. Next unhook, on the left, the fuel line, and on the right, a very thin black tube, the oil injection tube. there are a couple orange lines coming out the bottom, dont worry about them, they stay on. Next, unscrew the little side clip that unscrew the top of the carb. Be careful not to loose any pieces out of it. The carb shoudl then be free.
Turn it over, and there should be four little screws. Unscrew these, and take that cover off. look to see if there is any sediment, or anything blocking the floats.
Hope this helps
Josh
#5
Thanks a bunch Josh...your a life saver. BTW I was only gonna bring it to the dealer if the warranty would cover it. BTW I went back out after about a gallon of fuel leaked out. Started it right up and it ran almost perfectly....hesitated once.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)



