?Grizzly runs rough when warm with k/n filter-jetkit
#1
![Default](https://atvconnection.com/forums/images/icons/icon1.gif)
I have a GRIZZ 660. After it has been warmed up(rode for 45minutes to an hour) and either idles fo 3-4 minutes or is shut off then started again, it cuts out and runs rough. If I ride for a couple minutes with occasional full throttle, it clears up and runs fine. I have installed a K/N filter and jet kit with a 150 main, 2 and 1/2 turns out on the screw. I ride below 2000 ft. elevations. ANY HELP WOULD BE APPRECIATED!!!
#2
#3
![Default](https://atvconnection.com/forums/images/icons/icon1.gif)
I checked the plug. Black around the threads not too much around the ignitor though. I have a stock exhaust. Is the only carb adjustment to adjust the richness in the carb near the jet that I installed? A pain to have to take the carb off to adjust this. If I am reading the directions on the Dynojet kit correctly, I will need to turn the screw clockwise to lean out the mixture. I am thinking about 1/4 of a turn. Any other suggestions? What does a hotter plug do for you? Thanks so far!
#4
Thread
Thread Starter
Forum
Replies
Last Post
Big600twin
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
3
06-10-2015 03:01 PM
SOLOLUCKY
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
3
05-25-2015 05:25 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)