does anybody know the true tool to remove the flywheel from a kasea 50/90cc 2 stroke, i was told a yamaha tool would work and it is too big, can someone please help me.

 

On your flywheel, is there 2 threaded holes on each side of the center or a threaded center?
I'm betting on the 2 threaded holes which would require a puller. They usually come in a 2 or 3 leg puller.

 

I have a four screw fan, and there is a threaded center just like most, now I was told the center is a reverse clock center, question #2, any idea what size screws will fit in the holes, I was tempted to buy one but my plans were to use the 3 legs, but I feared warping the flywheel.

 

I saw a 24/27mm puller on eBay also, would tht be an option? I like the thought of being able to buy the 3 leg vs. Ordering.

 

I think you'll need the screw in puller.
Using 3 of 4 holes to pull on may cause damage.
Flywheels need to be pulled on virtually perfectly straight.

 

I agree with the above, now the issue is finding out the size of the threaded center, off t get a. CAliper, thanks lt80

 

You can call::
hetrickracing.com
maximumrpm.com
Either can surely help you.

Oh yea...FYI:: your kasea is a finely made Tiawanese machine, not a china thing. <EG>

 

thanks for the info lt80, i knew it was a taiwanese, just didn`t see a page for taiwan made atv`s.

 

ok i succeeded in removing the flywheel with a harmonic balancer puller, i was able to remove the oil injection gear, and sand down the magnets from rust and dirt, now waiting on my cdi to come in.