Full drag ATC 250R
#1
Full drag ATC 250R
Has anyone HERE done it or seen it done right? I watch the hillshooters at glamis run a lot and it seems that the quads have a weight transfer advantage, is this true? most of the ATC's I see out there are running a much longer swing arm (for obvious reasons) but the weight transfer just doesnt seem to do the trick on hard launching. Now I've seen guys run their forks in reverse (250R's) which puts the front wheel a fraction of a inch forward, but has anyone increased the angle of the forks to a more aggressive position? I would think this would lower the trike, put more weigh out front, and keep from the need of an outrageous(sp) swing arm. Any info on this is appreciated.
PS I'm not interested in doing this right away, just for future reference.
PS I'm not interested in doing this right away, just for future reference.
#2
Full drag ATC 250R
Iv have seen a few before. with 410 kits and they acually make a 460 kit for the ol R!! but any way they had to extend the swing arm ALOT liek 10 inches to make it not wheelie everytime. And also you want to put the front down as much as possible because youl go faster.
Thread
Thread Starter
Forum
Replies
Last Post
Quadzilla Heritage
Classifieds, Garage Sale & Swap Shop
0
09-25-2015 01:39 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)