Pami 725 Kit
#1
Pami 725 Kit
Who's running it?
What compression piston's are available?
What's the turn around time?
Any head or case modifications needed?
Can you run a stroker crank with it? 760?
Pami 725 Kit
What compression piston's are available?
What's the turn around time?
Any head or case modifications needed?
Can you run a stroker crank with it? 760?
Pami 725 Kit
#2
Pami 725 Kit
Right now, most are on German bikes. I have one that will finish up the next week. It should be a runner.
The compressions is 12-1.
Depending on if I have them or not, 2 to 3 days.
They are a direct bolt into the case. The head has to be clearanced for the 105.5 bore. The pami piston is almost flat for better flame travel than other bolt in pistons kits.
This kit was not set up for stroker cranks. (piston pin height, gasket thickness) There is nothing that interchanges with the other Pami kits. This is all custom HY-Tec pieces.
I now have a place in the states that does the cases and head clearances that I trust other than Pami.
The compressions is 12-1.
Depending on if I have them or not, 2 to 3 days.
They are a direct bolt into the case. The head has to be clearanced for the 105.5 bore. The pami piston is almost flat for better flame travel than other bolt in pistons kits.
This kit was not set up for stroker cranks. (piston pin height, gasket thickness) There is nothing that interchanges with the other Pami kits. This is all custom HY-Tec pieces.
I now have a place in the states that does the cases and head clearances that I trust other than Pami.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)