i need loading ramps for my trailer.. i need to get 2 quads in and they have to be sideways..i was going to use the ramps to drive up and over the rail so it will be loaded sideways ..i cant keep lifting and sliding these thing,it is to much work...

 

http://www.discountramps.com/atv_ramp_page.htm

 

I cut the side rail on one side of my trailer (in front of and behind the wheel, I left the side rail in tack over the wheel) Then I welded pockets from angle Iron to slide the ramps into.
The ramps now complete the side railing.

Now I can drive right up the side in front and right up the side in back (Just move the ramps.
No lifting required!

I don't have any pics of the trailer since I redone it, send me a PM with a email address. I will get a digital pic and send it to you.
Good Luck,
Chuck

 

I use a bi-fold ramp when loading it in my truck. The bi-fold is wide enough, and slip under the quad when its loaded. Tri-folds are too thick for this, and the rear brake rotor will hit the ramp and therefore wont fit underneath.

 

chirochris: i have folding ramps, you can check my pictures. they work great.

 

I bought the ramps below 2 years ago and they are great for little money

Ramps

 

harborfreight.com

search 'ramp'

 

I cut the railing off of one side of my trailer and installed fold down gate ramps it's the only way to go you will get tired of lifting and moving also storing them while in transport.

 

i picked up a pair from freight--- thanks guys(camds650)

49.99 plus 8 $ for shipping cant beat that


once again forum pulls thru!