Thanks a lot all. I was just being careful, but it looks like I need to put a little more muscle behind it. Thanks again.

 

send me your adress and you can have mine they are all the same rite?

 

When you reinstall the decompressor pin in the new cams. You will want everything to move easily. Push the decompressor in and it should spring back freely. If it doesn't. Ya gotta take it apart agian and clean the holes out in the cam itself where the pin goes through. In fact you should be able to slide that pin all the way through the holes in the cam by hand. When you get it like that. Then you can install the decompression mechinism and the pin. It will be almost as tough to install as it was to remove.
Take your time and good luck