I have 2 engines in my garage.

First one is complete, minus intake. Was running when removed, however, slipped out of 4th and 5th gears half the time. Never been inside it, but was told it had bigger piston, cams, and headwork. And it pulls alot better than my friends' stock DS.

Second engine is for parts. I never heard it run. Rod bearing is shot. Was told tranny is good.

 

Still need to move the mr.hp hv46 carb with red moose billet thumb throttle, adjustable cable and full race ported (mr.hp) intake manifold.




*EDIT** this is more of a "testing the waters" type of deal, but also may have a lectron 48hv with moose billet throttle and cable that would need to find its way out of my garage.

but I currently do need to see the 46 setup go ^^^

 

I still have a Graydon Proline rev box I keep tripping over.

 

Check you pm's. [img]i/expressions/face-icon-small-smile.gif[/img]

 

I can't seem to find a Dyno Jet kit in my garage! Anyone know where to look?

 

Update on my list,

Needing to fill my garage up with lots of stuff to trip over!!!
Engine, Running Or Not, Any Year
+2 to +4 Swingarm, Axle, Bearing Carrier,Caliper,Rotor,Sprocket Hub and Shock (Not Stock)
Pipe And Silencer (Woods?) Have Woods In-Frame Drag, Need Header And Mid Pipe, Silencer Wouldn't Hurt.
Various Pretty Stuff:Billet Bumper, Rear Grab Bar, Gas Cap.

Need To Clean Out:
2000-2001 Front End (Arms, Tie Rods and Stock Shocks)
Nerf Bars

Thanks,
Tom

 

i got a 01 yellow / blk seat cover thats in the way-----------(freebee)(nota)(zip)(zeelch) [img]i/expressions/face-icon-small-wink.gif[/img] just the brown truck--2-u -----already left on the brown truck

 

I still have a Ace +4 swingarm along with So Cal Fab +1+1 a-arms

I also have a trail ported head with shim unders installed (very low hours)

Stock full exhaust

 

I haven't had enough coffee this morning and accidently cleared my pm message history regarding the two engines in my garage.

 

my garage is in need of a big valve race head