What happened to Raceway?
#31
grease zirk ?
Yes grease nipple.
I got off track there I thought you were talking about your rear swing arm bushings/bearings.
As for the front control arm bushings you may want to Check Jetmoto's site as the 250 Jetmoto's actually use bearings in the front control arms. Perhaps they would fit??
My 150 jetmoto uses rubber bushings and the top ones need replacing. I'm thinking of maybe making some bushings for it too. Anyone with a lathe could make them up in no time.
Yes grease nipple.
I got off track there I thought you were talking about your rear swing arm bushings/bearings.
As for the front control arm bushings you may want to Check Jetmoto's site as the 250 Jetmoto's actually use bearings in the front control arms. Perhaps they would fit??
My 150 jetmoto uses rubber bushings and the top ones need replacing. I'm thinking of maybe making some bushings for it too. Anyone with a lathe could make them up in no time.
#32
lol you have crossed wires with me lol, go back and read what i put.....i am now looking for bushings for the front swing arms(A-arms) that are 34mm outer and 10 mm inner....no bearings....i was just saying to the other guy about the bearings where like hondas so the back ends maybe.
i have 8 of these bushings to replace and dont wanna go down the route of buying new swing arms from vbike just for the bushings as the whole front set of swing arms upper and lower come to $180 and it will still have the cheaper bushings in it....i try to replace all parts with better quality one as i go
i have 8 of these bushings to replace and dont wanna go down the route of buying new swing arms from vbike just for the bushings as the whole front set of swing arms upper and lower come to $180 and it will still have the cheaper bushings in it....i try to replace all parts with better quality one as i go
What did you want to pay for 8 of them? Any idea of what you would want them made out of? Oil lite Bronze or some kind of brass would be my thought...I have a lathe and could make a set...wonder how many other people would buy them? hmmmm
#33
I gotta stop reading to fast!!
What did you want to pay for 8 of them? Any idea of what you would want them made out of? Oil lite Bronze or some kind of brass would be my thought...I have a lathe and could make a set...wonder how many other people would buy them? hmmmm
What did you want to pay for 8 of them? Any idea of what you would want them made out of? Oil lite Bronze or some kind of brass would be my thought...I have a lathe and could make a set...wonder how many other people would buy them? hmmmm
#34
#35
#36
#39
god only knows....theres proberly some sweat shop paying 50c per day to some dreary slave to pump out thousands......also i found a guy up here today that has a lathe and said he "should be able to come up with something"
well i will keep you informed.....might have made you a little sideline with bushing production lol
well i will keep you informed.....might have made you a little sideline with bushing production lol
Thread
Thread Starter
Forum
Replies
Last Post
Sw00p
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
2
09-24-2015 02:50 PM
Elkaholic
Land, Trail and Environmental Issues
1
09-06-2015 02:44 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)