how much do clutches cost for recon?
#1
I was wondering how much do clutches cost for a recon because i think mine might be goign bad or something because when im taking off it works fine but when i get it in about 3rd gear you can feel it slipin if your givin it full throttle it does this in 4th and 5th to but then it will grap and work just fine hopefully its nothing in my transmission
98 recon stock
98 recon stock
#2
#4
Not the $95+ Honda tool for removing the centrifical clutch, I found that a Harmonic Balancer puller I had fit! It looks like a steering wheel puller (with 3 holes) that line right up with the 3 holes in the clutch.
To break the nut free on the clutch pack just put it in 4th or 5th gear and set the parking brake and loosen the nut. You don't need a holding tool this way and you can retorque the nut this way too.
To break the nut free on the clutch pack just put it in 4th or 5th gear and set the parking brake and loosen the nut. You don't need a holding tool this way and you can retorque the nut this way too.
#6
I recently replaced the clutches in my wifes Recon too. It was acting the same as yours as far as the slipping goes. After the new clutches, it is ok again. The old ones still looked good, but apparently they were the problem. I made my special tools with a big washer and a piece of key stock welded to the washer. It works good.
Thread
Thread Starter
Forum
Replies
Last Post
Lou Domenech
Classifieds, Garage Sale & Swap Shop
0
09-11-2015 06:35 PM
cdstang
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
2
08-31-2015 07:52 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)