On the EPI website they have a "clutch spring compression tool" for the Prairie/V-Force. Is that basically what you have? If I remember right, they want around $80 for it!

 

Yes, but they copied me. I should have patented it. I would have been richer than Bill Gates. Well maybe not quite that rich.

I am thinkin about marketing my own version, not to make a lot of dough on it, but because some people can't cut the pipe cap and some peole can't drill the big hole. I would probably just sell the piece that people can't make. They would have to get the nuts, threaded rod, and washers at the hardware store. That way, I could get it shipped via usps and not have to make special trips each time I sold one.