Need torque specs for:

1) Castle nuts on the front suspension knuckle
2) The 27MM Castle nut on drive shaft (hub)
3) A-Arm Bolts

Thanks!

 

suspension arm pivot bolts 65ft-lb(where the a arm bolts to the frame)
front axle nut 145 ft-lb(hub)
tie rod end nuts31 ft-lb
steering knuckle joint nut 31 ft-lb(where the ball joint slides into the knuckle)


This is what I found in my manual, I`m not sure if it is exactly what you need.

 

Thanks for the info. I torqued everything up. I replaced the a-arm bearings and seals and the wheel bearing on the left side. Thats hub nut is one bugger to torque on. Thank god it is done.

Thanks again.

 

No problem glad I could help.